Windows Operator's Console (Woc) Software Installation; Conventional Attendant Console; Installation; Conventional Attendant Console Programming - Toshiba strata CT Installation & Maintenance Manual

Station Apparatus

Windows Operator's Console (WOC) Software Installation

Note

Conventional Attendant Console

A Strata CT system configured with RCTUB2 can support two Attendant Consoles.
PC and conventional Attendant Consoles require processors in Strata CT.
The conventional attendant console can be configured with a Toshiba-supplied base (ATT
BASE-1) and an Electroluminescent (EL) or EGA Colour CRT.

Installation

Refer to
➤
To install the conventional attendant console
1.
H
2.
3.
4.
5.
C

Conventional Attendant Console Programming

Follow the same programming instructions provided for the PC attendant console. See
"Windows Operator's Console (WOC) Programming" on Page
and Windows instructions do not apply to the conventional console.
5-32
See the WOC-SFT Installation and Programming Guide shipped with each set of
WOC software.
"Hardware Installation" on Page 5-28
Plug in the EL or CRT display to the base with a nine-pin cable, which is supplied with
the display.
Plug in the EL or CRT display to a commercial three-prong AC 117V outlet.
Use two-pair wiring to connect the MDF to an RJ11 jack at the attendant console
location.
Plug in the handset to the base RJ45-jack
Plug in the headset (if needed) to the base.
and the following steps.
(see Figure 5-17).
5-30. Software Installation
Strata CT I&M Manual October 2000