Toshiba strata CT Installation & Maintenance Manual page 226

Peripheral Installation
Example 3 – DISA Outgoing Exchange Line Call
Note
Call Sequence C
Notes
H
C
Note
6-38
DISA Exchange line calls print out as DISA.
N
Outside caller rings Exchange line 001. (Line 001 is programmed as DISA.)
N
Line 001 returns intercom dial tone after two ring cycles (5~6 seconds).
N
Caller dials #7003 to access Exchange line 003 (outgoing).
N
Caller dials the DISA security code and receives Exchange dial tone.
N
Caller dials the telephone number and converses when the call is answered.
N
Caller hangs up.
N
The call releases, and Printout C prints after the call disconnects at 12:22.
If the Exchange provides the Calling Party Control or Auto Release (AR) signal (see
G
Program 15-0 and 15-3), the call disconnects when either party hangs up. A "*" will
precede the Exchange line number in Release 3 on the printout if the call is
disconnected by the CPC or AR signal.
If the CPC or AR signal is not sent, the Exchange lines will remain seized until the
G
DISA disconnect timer releases the call (see Program 12).
Printout C
Auto Release signal
003 MSS 12:20 00:00;03 00:05 DISA (outgoing)
*003 DISA 12:22 00:02;01 (outgoing)
001 DISA 12:22 00:02;01 (incoming)
Disconnect Timer
001 DISA 12:24 00:04;57 (incoming)
003 DISA 12:24 00:04;57 (outgoing)
The "MSS" entry prints out only if the call was connected after the SMDR
threshold, 1.0 or 10 seconds. The threshold is set in Program 60-2.
Strata CT I&M Manual October 2000