Peku Electronic Telephone Interface Unit; Peku Configuration To Support An Hdss Console Option; Peku Installation; Peku Programming - Toshiba Strata DK40 Installation & Maintenance Manual

PEKU Electronic Telephone Interface Unit

PEKU Configuration to Support an HDSS Console Option

1. Set the SW1 switch to DSS.
2. See
console requires dedicated use of circuits 7 and 8 of a particular PEKU PCB.

PEKU Installation

1. Make sure the PEKU has been configured for the appropriate hardware options.
"PDKU2 Hardware Options" on Page 3-4 for more information.
2. Insert the PEKU (component side facing right) into the appropriate slot, and apply firm,
even pressure to ensure proper mating of connectors. (For DK40, the PEKU can be
installed only in place of the RSTU2 or PDKU.
3. After installing the PEKU, gently pull the PCB outward. If the connectors are properly
mated, a slight resistance will be felt.

PEKU Programming

Program 03:
Note
Programs 28 and 29: HDSS console assignments.
Programs 77-1, 77-2, 79: HDCB and door phone ringing assignments
Strata DK40 I&M Manual Spring 1999
Refer to the Strata DK40 Programming Manual or DK Library CD-Rom for more details.
"HDSS Console" on Page 5-24
Specify Code 21 to indicate a non-optioned station line PEKU.
Specify Code 22 to indicate a PEKU configured for Speaker OCA.
Specify Code 23 to indicate a PEKU configured for an HDSS console.
Specify Code 24 to indicate a PEKU configured for Speaker OCA and an HDSS
console.
If there are no PEKU options, Program 03 can be skipped, and Program 91 - 1, or
91- 9 can be run instead.
for console installation instructions. Each HDSS
See Chapter 1 – DK40 Configuration.)
DK40 Universal Slot PCBs
See
3-7