Toshiba strata CT Installation & Maintenance Manual page 118

Universal Slot PCBs
PEMU Programming
Program 03: Specify Code 13 for slots that support PEMUs and make sure BRCS is enabled
for DTMF operation.
Program 04: Specifies [PDNs]. These are also the numbers that must be received by incoming
Tie lines to route calls to the proper telephones.
Program *09: Assigns Tie Line Ringing to ACD Groups.
Program 10-1: Enables/disables two-line conference.
Program 10-4: Assigns Toll Restriction (maximum number of Tie line calls dialling
simultaneously).
Program 10-5: Assigns privacy on Tie line transferred calls.
Program 12: Assigns various timing options to the Tie lines.
Program 15: Assigns tandem connections and dial pulse option to tie lines.
Program 16: Assigns Tie lines to line groups.
Program 17: Assigns immediate or wink start to PEMU tie lines.
Important!
Note
H
Program 39: Assigns line access buttons to digital and electronic telephones.
Program 40: Assigns station access to Tie lines (incoming and outgoing).
Program 41: Assigns station access to Tie lines (outgoing).
Programs 48 & *48: Assigns the level of Toll Restriction to the Tie Line Groups.
Program *53: Assigns outgoing digit translation.
Program *54: Assigns incoming digit translation.
C
Programs 50~56: Assigns LCR, if using the network as a route option.
Program 81 ~ 83: Tie to [DN] ringing assignments.
Program 93: Assigns a name to a tie line
3-24
Also used to turn on tie line dial tone return.
When a PEMU is installed in a system, it automatically assumes the next four
consecutive Exchange line numbers.
Strata CT I&M Manual October 2000