Toshiba strata CT Installation & Maintenance Manual page 185

➤
To install the WOC
H
C
Figure 5-17
Strata CT I&M Manual October 2000
See Chapter 4 – Universal Slot PCB Wiring
G
CAUTION! When installing the PC or conventional attendant console cable, do not run
the cables parallel to AC power if they are within three feet of an AC line.
AC power lines should be crossed at right (90
avoid running station wire pairs near devices that generate electrical noise,
such as neon or fluorescent light fixtures.
See Figure 5-17 and follow these steps:
1. Connect the RATI to the PC COM port a with a standard RS-232 cable.
2. Use one-pair wiring to connect the MDF to an RJ11 jack at the attendant console
location. If you need to use a long cable, use two-pair for more power.
3. Plug in the handset cradle to the RJ45-jack.
4. Plug in the headset (if needed) to the handset base.
5. After programming the Strata CT system, install the PC attendant console software and
complete the Telephony Setup per the instructions found on the WOC Installation &
Programming Guide shipped with each set of software.
Carbon Jumper
Headset Jumper
RATI Assembly/Disassembly
for attendant console wiring.
POW DTR DSR
RATI (Front View)
RATI PCB
DB9-FEMALE
(To PC COM Port Cable)
RJ11-JACK
(To RATU Modular Cord)
RJ45-JACK
(To RATHC Modular Cord)
REC OUT
(To Tape Recorder "RECORD" Input)
AUX IN
(Not Used)
Bottom Panel
Station Apparatus
°
) angles only. In particular,
5-29