Peripheral Installation
Power Failure Options
H
Reserve Power
Strata CT Power Failure Transfer Unit
C
Strata CT I&M Manual October 2000
This chapter provides connection procedures for optional peripheral equipment to Strata CT
Systems. Information in this chapter applies to all systems, unless stated otherwise in text.
Instructions include hardware requirements, PCB configuration, interconnection/wiring
requirements, and programming considerations. Peripheral equipment is connected to system
PCBs. See
Chapter 4 – Universal Slot PCB Wiring
and the appropriate installation section.
In the event of a power failure, Strata CT uses these options:
For information on the Reserve Power Option, see Chapter 2,
An optional Power Failure Transfer Unit (DPFT) can be installed that automatically connects
up to eight selected Exchange lines directly to designated standard telephones in the event of
a power failure. The DPFT enables normal operation of the selected Exchange lines and
standard telephones when the system is in service. When power is restored, each telephone is
independently reconnected to system standard telephone circuit ports after it is finished with
its direct Exchange line call. The DPFT is normally installed on the MDF.
Figure 6-1
provides a circuit diagram of the DPFT.
Note
The DPFT option is only available with annlogue exchange lines.
installation and configuration information
"Reserve Power" on Page
6
2-4.
6-1