Input Channels; Stereo Channels; Signal Flow For Input Channels; Mono Channels - Yamaha CL5 Reference Manual

Input channels

This chapter explains various operations for input channels.

Signal flow for input channels

The input channels comprise the section that processes signals received from the I/O
devices, rear panel input jacks, or slots 1-3, and sends them to the STEREO bus, MONO bus,
MIX buses, or MATRIX buses. There are two types of input channels, as follows.

MONO channels

These channels are used to process monaural signals. When the CL series console is in the
default state, the input signal from the Dante connector is assigned.

STEREO channels

These channels are used to process stereo signals. When the CL series console is in the
default state, the input signal from the EFFECT RACK 1 - 8 is assigned.
M
O • INPUT PATCH
MIX ST N MATRIX CUE
O
1 2 ... 2324 L R(C) 1 2 ... 7 8
L R
Assigns input signals to the input channels.
• Ø (phase)
Switches the phase of the input signal.
• DIGITAL GAIN
Attenuates/boosts the level of the input signal.
• HPF (High Pass Filter)
Cuts the region below the specified frequency.
• 4 BAND EQ (4 band equalizer)
A parametric EQ with four bands: HIGH, HIGH MID, LOW MID, and LOW.
• DYNAMICS 1
This is a dynamics processor that can be used for gating and ducking, or as an expander
or compressor.
• DYNAMICS 2
This is a dynamics processor that can be used as a compressor, compander, or de-esser.
• INPUT DELAY
Corrects input signal delay. You can specify up to 1000ms.
• LEVEL/DCA 1-16
Adjusts the input level of the effect.
• ON (On/off)
Turns the input channel on or off. If this is off, the corresponding channel will be muted.
26
Input channels
M
O
N
ST
MIX MATRIX CUE
O
1 2 2324 L R(C) 1 2 7 8 L R
Reference Manual