Yamaha CL5 Reference Manual page 21

• If you exceed the INSERT OUT or INSERT IN limitation, the
• If the limit is exceeded, invalid ports will be marked with a strike-out line.
• If the limit is exceeded, the following ports will take priority per channel group (listed in the table
above).
1
INSERT 1 will take priority over INSERT 2.
2
Lower-number channel will take priority.
INSERT/DIRECT OUT screen (1ch)
indicator will light up on the left.
1
2
◆ INSERT field
This field enables you to make insert settings. Press one of three fields to choose PRE EQ
(immediately before the EQ), PRE FADER (immediately before the fader), or POST ON
(immediately after the [ON] key) as the insert position.
1
2
3
4
5
21
3 < 6 7 8
4
NOTE
You can set the I/O ports to function as an insert for each block.
INSERT OUT button
Displays the currently-selected output port for insert 1 and insert 2. Press this button to
open the PORT SELECT window, in which you can select an output port.
INSERT IN button
Displays the currently-selected input port for insert 1 and insert 2. Press this button to
open the PORT SELECT window, in which you can select an input port.
INSERT ON/OFF button
Switches the insert on or off.
APPLY TO ALL INPUT button (input channels only)
Specifies whether the insert position and direct out point setting will be applied to all
input channels.
APPLY TO ALL OUTPUT button (output channels only)
Specifies whether the insert point setting will be applied to all output channels.
NOTE
Insert 1 and insert 2 are serial connections with fixed sequential numbers.
Input and output patching
< 9
5
Reference Manual