Yamaha CL5 Reference Manual page 121

Mode = PINK NOISE
• LEVEL knob ..........Indicates the output level of the pink noise. You can adjust the
value by using the multifunction knob.
• HPF knob ..............Indicates the cutoff frequency of the HPF that processes pink
noise. You can adjust the value by using the multifunction knob.
Use the button below the knob to switch the HPF on or off.
• LPF knob...............Indicates the cutoff frequency of the LPF that processes pink
noise. You can adjust the value by using the multifunction knob.
Use the button below the knob to switch the LPF on or off.
Mode = BURST NOISE
• LEVEL knob, HPF knob, and LPF knob
....................Same as in PINK NOISE mode.
• WIDTH ...................Indicates the length of noise being output intermittently. You can
adjust the value by using the multifunction knob.
• INTERVAL..............Indicates the length of silence between noise bursts. You can
adjust the value by using the multifunction knob.
Level
Pink noise output
INTERVAL
WIDTH
Turn BURST NOISE button on.
Time
118
3 ASSIGN section
Enables you to select a channel to which the oscillator signal will be sent. Press one of
the three tabs below to select the type of channels displayed, and then press the
button(s) for the desired channel(s) (multiple selections are allowed). The "ASSIGNED"
indicator is lit green for a tab that contains a selection.
If the mode is set to SINE WAVE 2CH, the signal is output to either odd (ODD(L) side)
or even (EVEN(R) side) of the selected channel. For example, the signal set to ODD(L)
is output in MIX1, and the signal set to EVEN(R) is output in MIX2.
You can press the CLEAR ALL button to defeat all selections.
NOTE
In the case of the CL3/CL1, channels that do not exist on those models will not be shown.
4
Meter section
Indicates the oscillator output level.
5
OSCILLATOR OUTPUT button
Turns the oscillator output on or off. If you turn this button on, the oscillator signal will be
sent to the input channel or bus you selected in the ASSIGN section. When you press
the button again, the oscillator will turn off.
Talkback and Oscillator
Reference Manual