Table of Contents
Advertisement
3. Preventive Maintenance
PM Parts Settings
Replacement Procedure of the PM Parts
There are two ways to reset the PM counter for this machine.
"Method 2 By [PM Counter / New Unit Set] Menu" is recommended for its ease of operation.
• After the PM counter for the fusing sleeve belt unit reaches its PM life (400K pages or
313,153,000 mm), the machine stops the operation automatically. Replace the fusing sleeve belt
unit before the machine stops its operation (stop warning: 415K pages or 302,229,000 mm, stop:
430K pages or 313,153,000 mm).
• For the following units, there is a new unit detection mechanism. It is not necessary to set SPs (New
Unit Detection).
- Fusing unit as a complete unit
- PCDU as a complete unit
- Waste Toner Bottle (When the machine stopped because the waste toner bottle was full)
Method 1: By SP3701
1.
Enter the SP mode.
2.
Output the SMC logging data with SP5-990-004.
Make sure to shut down and reboot the machine once before printing the SMC. Otherwise, the
latest settings may not be collected when the SMC is printed.
3.
Set the following SPs (New Unit Detection) to "1".
Development unit
• Replacement procedure: page 462
Item
SP
Black: SP3-701-003
Yellow: SP3-701-072
Cyan: SP3-701-026
Magenta: SP3-701-049
389
Advertisement
Table of Contents
Troubleshooting
