Docuscan C4250 - Fuji Xerox DocuScan C4250A Setup And Quick Reference Manual

Using the Document Feeder

(DocuScan C4250)

Up to 50 sheets of documents (plain paper: 60 -
2
100 g/m ) of sizes ranging from 100.0 x 148.0 mm
to 297.0 x 432.0 mm can be scanned at once
using the document feeder. When scanning more
than 50 sheets, feed 50 sheets or less at a time.
Note
• When scanning more than 50 sheets, select [Next
Original] while the first 50 sheets are being scanned,
and load the next 50 sheets or less to scan all
documents as a single job. For more information, refer
to "Start the scan job" (P.47), "Start the scan job"
(P.53), "Start the scan job" (P.53), or "Start the copy
job" (P.57).
The document feeder feeds documents from the
top of the stack and outputs them face down. Use
the following procedure when loading documents
into the document feeder.
1. Remove all staples and paper clips from the
documents and align their edges.
2. Insert the documents into the document
feeder face up. Align the documents with the
left and rear edges of the document feeder
tray.
When the documents are loaded correctly,
the document indicator lamp lights up.
3. Position the document guide to just touch the
edge of the documents.
36
3 Basic Operation
Important
• Keep the followings in mind to prevent the documents
from being jammed or damaged:
• Do not hold the documents while they are being
fed into the document feeder.
• Constantly remove the documents from the
document output tray after they are output (Do not
leave them on the tray until they are piled up).
• Do not put any objects on the document output
tray.
Using the Document Feeder
(DocuScan C3200 A)
Up to 50 sheets of documents (plain paper: 60-
2
100 g/m ) of sizes ranging from 140.0 x 140.0 mm
to 215.9 x 355.6 mm can be scanned at once
using the document feeder. When scanning more
than 50 sheets, feed 50 sheets or less at a time.
Note
• When scanning more than 50 sheets, select [Next
Original] while the first 50 sheets are being scanned,
and load the next 50 sheets or less to scan all
documents as a single job. For more information, refer
to "Start the scan job" (P.47), "Start the scan job"
(P.51), "Start the scan job" (P.53), or "Start the copy
job" (P.57).
The document feeder feeds documents from the
top of the stack and outputs them face down. Use
the following procedure when loading documents
into the document feeder.
1. Remove all staples and paper clips from the
documents and align their edges.
2. Insert the documents into the document
feeder face up (If the documents are 2 sided,
their front sides should face up). Make sure
that the documents are loaded all the way
into the document feeder.