7.
Select the method of obtaining an IP
address, and select [Save].
In this example, we will select [Manual].
2. Get IP Address
DHCP
BOOTP
RARP
The [Protocol Settings] screen appears.
8.
Select [3. IP Address], and select [Change].
Protocol Settings
Items
1.
Ethernet Setting
2.
IGet IP Address
3.
IP Address
4.
Subnet Mask
5.
Gateway
9.
Enter the IP address using the numeric
keypad. The IP address must be in a format
of xxx.xxx.xxx.xxx (where xxx is a number
between 0 to 255).
3. IP Address
192 . 168 . 1 . 100
10. Select [Save].
11. As necessary, repeat the preceding steps to
set a subnet mask and gateway.
12. Select [Close] repeatedly until you return to
the [System Settings] screen.
24
2 Network Settings
Cancel
Save
DHCP/Autonet
Manual
Close
Change
Current Settings
Auto
Manual
0.0.0.0
1/1
0.0.0.0
0.0.0.0
Cancel
Save
Starting CentreWare
Internet Services
CentreWare Internet Services is a service that
allows you monitor or remotely configure the
scanner using a web browser on a TCP/IP
network.
Before using the Scan to E-mail or Scan to PC
feature on the scanner, configure the following
settings using CentreWare Internet Services.
To use Scan to E-mail:
• Set the e-mail parameters.
• Set the DNS parameters.
Refer to
• "Setting the E-mail Parameters" (P.28)
• "Setting the DNS Parameters" (P.28)
To use Scan to PC:
• Set the DNS parameters.
• Set the WINS parameters.
Refer to
• "Setting the DNS Parameters" (P.28)
• "Setting the WINS Parameters" (P.30)
Note
• Set the DNS and WINS parameters as necessary.
Getting Ready
Check the control panel to see if CentreWare
Internet Services is acivated.
1.
Select [Network Settings].
System Settings
Common Settings
Copy Settings
System Admin.
Settings
Close
Network Settings
Scan Settings