September - Genie AWP Super Series Service Manual

Service Manual
Platform
12 Remove the lower sprocket housing mounting
fasteners. Do not allow the chain to become
twisted.
13 Remove the upper sprocket housing mounting
fasteners. Do not allow the chain to become
twisted.
14 Remove the fasteners from the outreach
locking bracket.
15 Slide the platform mount off the inner frame
extension arms and set it aside.
16 Locate the two allen head screws in the
platform mount slide pad.
17 Remove the roller from the same side of the
slide pad.
18 Remove the two allen head screws.
19 Remove the master link from the chain.
20 Pull the chain out of the slide pad and both
sprocket housings.
21 Install the new chain through the slidepad.
22 Push the chain through the slide pad until
approximately 2 inches / 5 cm of the chain is
extended past the slide pad.
23 Install the two allen head screws. Install the
roller wheel.
106
24 Thread the chain through the upper sprocket
25 Thread the chain through the lower sprocket
26 Do not re-use the old master link. Install a new
27 Slide the platform mount onto the extension
28 Install the outreach locking bracket on the
29 Install the upper sprocket housing to the
Note: When fasteners are installed, be sure the
center bolt is in between the two chains inside the
housing.
30 Pull the slack out of the chain by pushing
31 Install the lower sprocket housing fasteners.
32 Adjust the chain. Refer to Repair Procedure,
33 Install the outreach assembly onto the
AWP Super Series • IWP Super Series
housing over the sprocket, then back through
the housing.
housing over the sprocket, then back through
the housing. Don't allow the chain to become
twisted.
master link.
arms.
platform mount.
platform mount.
down on the lower sprocket housing.
How to Adjust the Platform Outreach Chain.
carriage.

September 2016

Part No. 38139