Genie AWP Super Series Service Manual page 49

September 2016
5 Insert the retaining pin into the strut socket.
Crushing hazard. The machine
will fall if the retaining pin is not
locked into the strut socket.
6 Slide out the T-handle until the lock pin snaps
into the locked position.
Crushing hazard. The machine
could fall if the T-handle lock pin
is not locked into the base.
7 Lift the machine with the T-handle to the
mid-tilt position (casters on tilt-back frame
contact the floor, and machine supported by
the extended tilt-back strut). Use the
appropriate number of people and proper
lifting techniques.
Part No. 38139
8
9
10 Lower the machine with the T-handle until
11 Return the sliding T-handle to stowed position.
12 Stow the tilt-back frame in the upright position
AWP Super Series • IWP Super Series
Checklist B Procedures
Continue lifting until telescoping tilt-back strut
is completely compressed.
Return the machine to the standing position.
Carefully pull down T-handle until machine
rests at mid-tilt position.
base casters are in contact with the ground.
Use the appropriate number of people and
proper lifting techniques.
and insert the retaining pin.
Service Manual
49