Platform Outreach Chain - Genie AWP Super Series Service Manual

September 2016
7-3 Platform Outr eac h C hain
7-3

Platform Outreach Chain

How to Adjust the Platform
Outreach Chain, IWP-20S Models
1 Fully lower the platform.
2 Turn the key switch off and remove the key.
3 Fully extend the platform outreach. Lock the
handle in position.
4 Place a block of wood between the carriage
and the platform outreach to prevent the
outreach from collapsing when the fasteners
are loosened.
Crushing hazard. The platform
outreach will collapse if it is not
properly supported when the
fasteners are loosened.
5 Locate the lower sprocket housing fasteners.
6 Loosen but do not remove both sprocket
housing fasteners.
7 Push downward on the sprocket housing to
remove excess slack from the chain.
8 Tighten the sprocket housing fasteners.
9 Confirm proper chain adjustment. Refer to
Maintenance Procedure, Check the Chain
Adjustment.
Part No. 38139
How to replace the Outreach
Chain, IWP-20S Models
1
2
3
4
5
6
7
8
9
10 Lay the outreach assembly onto a workbench
11 Place a block of wood under the inner frame
AWP Super Series • IWP Super Series
Fully lower the platform.
Turn the key switch off and remove the key.
Pull the base lowering handle to fully lower the
base.
Remove the platform.. Refer to Repair
Procedure, How to Remove an Aluminum
Platform.
Remove the platform control box cover
fasteners and open the control box.
Remove the platform control box mounting
fasteners. Remove the platform control box
and set it aside.
Extend the outreach approximately 14 inches
/36 cm. Lock the handle in position.
Attach an overhead crane to the center brace
pivot pin on the outreach assembly.
Remove the assembly mounting fastener.
Crushing hazard. When the
mounting fasteners are removed,
the platform outreach will become
unbalanced and may fall if it is not
properly supported.
or table of ample capacity. Be sure the chain is
facing up.
assembly for support while removing the
chain.
Crushing hazard. The platform
outreach will collapse if it is not
properly supported when the
chain is removed.
Service Manual
Platform
105