Genie AWP Super Series Service Manual page 102

Service Manual
Tilt-back Frame, AWP-36S and 40S Models
How to Disassemble the Shock
Absorber
1 Fully lower the platform.
2 Turn the key switch off and remove the key.
3 Maintain a firm grasp on the tilt-back frame
and remove the retaining pin. Lower the
tilt-back frame to the ground.
4 Remove the fastener that mounts the shock
absorber assembly to the frame.
5 Remove the shock absorber assembly from
the frame and separate the lower tube from
the assembly.
6 Pull the shock absorber out of the upper tube.
7 Remove the metric nut from each end of the
shock absorber and remove the mounting
blocks.
Bodily injury hazard. Contents of
the shock absorber are under
pressure. Use care during
removal.
102 AWP Super Series • IWP Super Series
1 shock absorber
2 lower shock mounting block
3 lower tube
4 upper tube
5 upper shock mounting block
September 2016
Part No. 38139