Write To Parameter Area (Mrc = "02", Src = "02") - Omron E3X-DRT21 Operation Manual

CompoWay/F Message Communications
4-5-5

Write to Parameter Area (MRC = "02", SRC = "02")

Command Block
Response Block
86
Response
code
"2203" Operation error
Writes the following data to the parameter area.
Item
Write Number of Sensors
Connected
Write Response Delay
Time
Write Threshold Setting
Write Basic Settings
Write Timer Setting
Write Hysteresis Width
Write Custom Flags
Write Special Flags
Note An error will occur if the unit number of an E39-TM1 Terminal Block Unit is
specified.
The following diagram shows the command text in the CompoWay/F com-
mand block.
MRC SRC
"02" "02"
2 bytes 2 bytes
Number of elements
"8001"
4 bytes
The following diagram shows the command text in the CompoWay/F response
block.
MRC SRC
"02" "02"
2 bytes 2 bytes
Note 1. When WRITE commands are executed, the settings are written to the in-
ternal memory. The number of times that data can be written to the internal
memory is limited. The internal memory may be corrupted if more than one
million (1,000,000) write operations are performed for each Sensor and pa-
rameter. Therefore, when using the Write to Parameter Area, be sure to
create a communications program that prevents the number of writing op-
erations from exceeding one million (1,000,000) for each Sensor and pa-
rameter
Error name
• A Sensor communications error has occurred.
• The Sensor response indicated a communica-
tions prohibited error.
• The Sensor did not respond.
• The Mobile Console is connected.
Variable
type
"8005" "0000"
"8006" "0000"
"8011" Unit number
"8012" Unit number
"8013" Unit number
"8016" Unit number
"8017" Unit number
"801C" Unit number
Parameter type
4 bytes
Write data
4 bytes
Response code
4 bytes
Section 4-5
Cause
Read start Number of
address elements
"8001"
"8001"
"8001"
"8001"
"8001"
"8001"
"8001"
"8001"
Write start address
4 bytes