Digital Fiber Amplifier Unit
E3X-DA-S
Stable Detection with Advanced Fiber
Amplifier Units
• A wide range of added value with standard models with one
input and two outputs, and ultra-long-term APC models with an
APC life of approximately 20 years.
• Power turning to easily set the optimum light level.
• Automatic Power Control (APC) is always enabled to stabilize
emitter power with high accuracy.
• GIGA RAY for stable detection with the highest level of power in
this class even for low-reflective objects and large objects.
• The E3X-DA0-S supports an EtherCAT Sensor Communications
Unit or CompoNet Sensor Communications Unit.
Ordering Information
Fiber Amplifier Units
Pre-wired Models and Wire-saving Connector Models [Dimensions➜page 27]
Type
Appearance
Standard
models
Ultra-long-term
APC models
High-speed
response
models
*1. A Wire-saving connector sold separately is required.
*2. These models allow you to use an E3X-DRT21-S VER.3 Sensor Communications Unit. When using the E3X-DRT21-S VER.3, use an E3X-
CN02 Connector without a Cable for the Wire-saving Connector.
Sensor Communications Unit Connector Models (for EtherCAT and CompoNet) [Dimensions➜page 29]
Type
Appearance
Standard
Connector for Sensor Communications Unit
model
Connecting
method
NPN output
Pre-wired
E3X-DA21-S 2M
(2 m)
Wire-saving
E3X-DA7-S
*1
connector
Pre-wired
E3X-DA21R-S 2M
(2 m)
Wire-saving
E3X-DA7R-S
*1
connector
Pre-wired
E3X-DA21F-S 2M
(2 m)
Wire-saving
E3X-DA7F-S
*1
connector
Connecting method
For the most recent information on models that have been certified for
safety standards, refer to your OMRON website.
Model
PNP output
E3X-DA51-S 2M
*2
*2
E3X-DA9-S
E3X-DA51R-S 2M
E3X-DA9R-S
E3X-DA51F-S 2M
E3X-DA9F-S
Model
E3X-DA0-S
Applicable wire-saving connector
(sold separately)
Type
Model
---
---
Master
E3X-CN21
connector
Slave
E3X-CN22
connector
---
---
Master
E3X-CN21
connector
Slave
E3X-CN22
connector
---
---
Master
E3X-CN11
connector
Slave
E3X-CN12
connector
Applicable Sensor
Communications Unit
E3X-ECT
E3X-CRT
1