Configuring A Macintosh To Support A Dhcp-Enabled Terminal - Hughes HN7000S User Manual

Configuring a
MacIntosh to support a
DHCP-enabled terminal
6. Type the appropriate IP address from the range of available IP
addresses in the
IP Address
not use the numbers in the examples, which are for
illustrative purposes only.
7. Select the Apply Now button. The Mac is now configured.
Follow the steps below to configure a terminal with DHCP
enabled on a MacIntosh system.
1. Select
System Preferences
Systems Preference menu appears.
2. Select the
Network
Network screen shown in Figure 52 appears.
Figure 51: Mac System Preferences menu
Appendix B • Typical operating system settings
field. See page 49 for details. Do
from the Mac interface. The
icon, which is circled in Figure 51. The
1037073-0001 Revision A
69