Device Control Window; Issues And Troubleshooting; Satellite Temporary Fixed Terminal States - Hughes HN Series Interface Manual And Reference

Acquisition Message
Modem State
Modem Msg:
Command Result:

Device Control Window

A Device Control Window is not needed for monitoring operation and is not included in the software.

5. Issues and Troubleshooting

5.1. Satellite Temporary Fixed Terminal States

Modem
Modem Msg
State
0 ST Rebooting
1
Uninstalled-
2 Installation
Recommended
3 Pointing – INIT
4 Pointing – Coarse
5 Pointing – FCS
6 FCS Failure
Informational message as returned from the AAQ about the current
acquisition.
Indicates the modem current STFT state (numerical). Refer to the table below
(Figure 9) for each modem state.
A short description of the current STFT state
Message returned from the Hughes modem in reference to current
command.
Phase
Boot,
Commissioning
IDLE None
Boot
Boot
Boot
Boot
Boot
Hughes HN
Description
Satellite Terminal is rebooting
Controller and modem/router
are not communicating
Modem/router has not been
installed properly
Modem/router parameters
are intializing for pointing
Coarse pointing is in process
Final Cell Selection
Selected cell is not viable for
this location
Action
No action
necessary
Typically this is only
during
transportation
Have the Satellite
Terminal
professionally
installed
No action
necessary
No action
necessary
No action
necessary
Must change
locaions
12