System Requirements - Hughes HN7000S User Manual

System requirements

Chapter 1 • Introduction
2
1037073-0001 Revision A
with Ethernet cable or through a wireless base station, and
configure your computers' operating system network properties.
The terminal has a System Control Center that provides access to
system information such as your site account number (SAN), site
ID, terminal Internet Protocol (IP) address, and subnet mask; the
terminal IP address and the subnet mask may be required to
configure a network. The System Control Center is described in
Chapter 2 – System Control Center, on page 7.
The instructions in this manual also apply to the enterprise-class
HN7700S terminal. The HN7700S terminal includes the
functionality of an HN7000S terminal in addition to being
equipped with an internal telephone modem, serial port, and two
Ethernet ports. The model number appears on a label next to the
DC IN connector on the back of the terminal.
In this guide, the terms remote terminal and terminal may refer to
an HN7000S or HN7700S model remote terminal. The terms
HN7000S and HN7700S are used when it is necessary to
differentiate between the two models.
Make sure your computer meets the following minimum
requirements to achieve optimal terminal performance:
• Operating system
– PC: Windows 98 Second Edition (SE), Windows
Millennium Edition (Me), Windows 2000, Windows XP
– MAC: 10.1 or higher
• Processor
– PC: Pentium II 333 Mhz or faster
– MAC: 300 Mhz or faster
• Memory
– PC: 64MB RAM, Windows 98SE and Me; 128MB RAM
Windows 2000 and XP.
– MAC: 128MB
• Free hard drive space
– PC: 100MB
– MAC: 150MB