Hughes HN7000S User Manual page 31

–
Software Release
HN7000S. Typically, this is the factory-installed software
version. If the NOC downloads a newer version of
software to your HN7000S, the newer software version is
displayed in this field.
– - the IP address of the HN7000S on the user's
IP Address
LAN.
– - defines the range of addresses assigned to
Subnet Mask
the HN7000S.
• Satellite
– - satellite longitude.
Longitude
–
Receive Frequency
the HN7000S.
–
Receive Polarization
either horizontal or vertical.
– - IP address of the primary router at the
Router Address
NOC used to route data sent by the HN7000S.
• Software Configuration - Turbo Page, network address
translation (NAT), the firewall, and dynamic host
configuration protocol (DHCP) are enabled or disabled
depending on the service offering purchased by the customer.
These settings cannot be changed by the customer.
–
Network Address Translation
allow multiple computers to share a single address on the
Internet. It also allows pre-configured remote networks to
be integrated easily with the network.
–
Dynamic Host Configuration Protocol
this simplifies the network configuration of the computers.
The computers need to be configured to automatically
obtain IP addresses.
– - if enabled, allows you to specify packet filtering
Firewall
rules.
– - if enabled, speeds web browsing.
Turbo Page
• Transmit Radio Info
–
Transmit Radio Name
antenna assembly (if available).
–
Transmit Radio Part Number
(if available).
–
Transmit Radio Wattage
watt transmit radio is on the antenna assembly.
- version of the software on the
- transponder frequency configured for
- polarization orientation, which is
(NAT) - typically used to
(DHCP) - if enabled,
- name of the transmit radio on the
- transmit radio part number
- indicates whether a 1 watt or 2
Chapter 2 • System Control Center
1037073-0001 Revision A
17