Pedestal Base - Hughes HN7000S User Manual

Pedestal base

Chapter 4 • Troubleshooting
42
1037073-0001 Revision A
Follow the instructions below to place the terminal in the pedestal
base, or remove it from the base.
You do not have to use the pedestal. You can place the terminal in
a horizontal position if you prefer. If you do this, do not place
objects on top of the terminal. Doing so may damage the unit by
interfering with air circulation, which cools the unit.
1. Position the remote terminal and pedestal base as shown in
Figure 26.
Figure 26: Attaching the terminal to the pedestal base
2. Align the bottom set of ventilation openings on the remote
terminal with the guides on the pedestal base.
3. Gently slide the remote terminal into the pedestal base until
the remote terminal locks into position.
Note: If you need to remove the terminal from the pedestal base,
pull up and back on the tab on the back of the base. You can then
slide the base off the terminal.