Siemens SCALANCE X-300 Configuration Manual page 204

Configuration using Web Based Management and Command Line Interface
4.5 The Switch menu
admedge [<T|F> [ports]]
autoedge [<T|F> [ports]]
ptp [<A|T|F> [ports]]
204
Command
Specifies whether a
•
or a
•
is connected to this port that supports
Spanning Tree or Rapid Spanning Tree.
If a (rapid) spanning tree protocol is
received, the value F is displayed.
Specifies whether at this port it should
be automatically detected whether a
•
or a
•
is connected.
The point-to-point link establishes a
direct link between two switches.
In this case, you have the following
options:
•
•
•
Description
T
End device
F
switch
T
End device
F
switch
A
The port recognizes a PtP port
based on the duplexity. If the con-
nection is full duplex, it is assumed
to be PtP, if it is half duplex, no PtP
connection is assumed (shared me-
dium).
T
Specifies a PtP link, even though
half duplex is being used.
F
Specifies that there is no PtP link
over the relevant port even with full
duplex.
Configuration Manual, 10/2014, C79000-G8976-C187-22
Comment
Administrator only.
-
SCALANCE X-300 / X-400