Dedicated Cc-Link Cable - Mitsubishi FX2N-16CCL-M User Manual

FX2N-16CCL-M CC-Link System Master Block
Dedicated high-performance CC-Link cable (for the CC-Link system V 1.10)
(requiring terminal resistor of 130 Ω)
When the entire system consists of only equipment and cables V 1.10, the following
advantages are offered.
1) The cable distance between two stations is defined to 20 cm or more in any condition.
2) Because the degree of freedom in the cable length is improved, the wiring work and the
system layout become easier.
3) Because excessive cable length does not have to be assured when modules are located
near each other, the space efficiency is improved.
4) Cables produced by diversified manufacturers can be used at the same time.
Table 4.4:
Transmission
speed
156kbps
625kbps
2.5Mbps
5Mbps
10Mbps
Example:
When remote I/O stations and remote device stations are connected with dedicated high-
performance CC-Link cables and the transmission speed is set to 10 Mbps, the maximum
transmission distance is "100 m".
Master station
4.5

Dedicated CC-Link Cable

Use dedicated CC-Link cables in the CC-Link system.
If any other cable is used, the performance of the CC-Link system cannot be guaranteed.
Cable length between stations
20 cm or more
1st module 2nd module
Remote I/O Remote device
station station
1m 50cm
*1 *2
3rd module 4th module
Remote I/O Remote I/O
station
35cm 50cm
100 m maximum
Specification 4
Maximum
transmission
distance
1200m
900m
400m
160m
100m
10th module
Remote device
·······
station station
4-5