FX2N-16CCL-M CC-Link System Master Block
Point
•
In debugging (startup) in which set values of parameters are not determined, set
parameters by executing "setting and operation using the buffer memory" (Refer
to 7.3.1.).
•
After debug (startup) is completed, register parameter set values to the
EEPROM, then execute "operation based on parameters registered in the
EEPROM" (Refer to 7.3.2.).
However, when a work for setting parameters again is expected accompanied by
changes and additions to the system after operation, operation can be executed
using a program for "setting and operation using the buffer memory" without
registering parameter set values to the EEPROM.
Parameter Setting 7
7-2