General Names And Abbreviations - Mitsubishi FX2N-16CCL-M User Manual

FX2N-16CCL-M CC-Link System Master Block
1.2

General Names and Abbreviations

Unless otherwise specified, this manual uses the general names and abbreviations shown in
the table below to describe the CC-Link system master block FX
Table 1.2:
General name/
abbreviation
FX -16CCL-M
2N
Cyclic transmission
Master station
Local station
Remote I/O station
Remote device station
Remote station
Intelligent device station
Standby master station
Master block
SB
SW
RX
RY
RWw
RWr
Abbreviation of the CC-Link system master block FX
Transmission method to periodically communicate the contents of remote
I/Os and remote registers.
Station which controls the data link system.
One master station is required in one system.
Station equipped with CPU which can communicate with the master station
and other local stations in the CC-Link system of the MELSEC-A/QnA/Q
Series.
Remote station which deals with bit information only (to execute I/Os with
external equipment) (such as AJ65BTB1-16D and AJ65SBTB1-16D).
Remote station which deals with bit information and word information
(to execute I/Os with external equipment and exchange analog data)
(such as FX -32CCL, AJ65BT-64AD, AJ65BT-64DAV and AJ65BT-64DAI).
2N
General name for remote I/O station and remote device station.
Controlled by the master station.
Station which can execute transient transmission (such as AJ65BT-R2) in the
CC-Link system of the MELSEC-A/QnA/Q Series.
Station for backup which takes over data link control when the master station
is disconnected due to abnormality in the PLC CPU, the power supply, etc. in
the CC-Link system of the MELSEC-A/QnA/Q Series.
Abbreviation for FX -16CCL-M.
2N
Link special relay (for CC-Link).
1-bit information which indicates the operation status and the data link status
of the master/local station.
Represented in "SB" for convenience.
Link special register (for CC-Link).
16-bit information which indicates the operation status and the data link
status of the master/local station.
Represented in "SW" for convenience.
Remote input (for CC-Link)
1-bit information input from a remote station to the master station.
Represented in "RX" for convenience.
Remote output (for CC-Link)
1-bit information output from the master station to a remote station.
Represented in "RY" for convenience.
Remote register (write area for CC-Link)
16-bit information output from the master station to a remote device station.
Represented in "RWw" for convenience.
Remote register (read area for CC-Link)
16-bit information input from a remote device station to the master station.
Represented in "RWr" for convenience.
-16CCL-M.
2N
Description
-16CCL-M.
2N
Introduction 1
1-2