Ip Igmp Max-Group - Planet WGSW-28040 Command Manual

<1-128>
[interfaces
IF_PORTS]
Mode:
Interface Configuration
Usage Guide:
After create ip igmp profile entry. Can use 'ip igmp filter 1' to bind a profile for port.
When the port bind a profile. Then the port learning group will update, if the group is not match the profile rule it will
remove the port from the group. static group is excluded.
The configure can use 'show ip igmp filter ' to display
Example:
The following example specifies that set ip igmp filter test.
The configure must create ip igmp profile firstly.
Switch(config)# ip igmp profile 1
Switch(config-igmp-profile)# profile range ip 224.1.1.1 224.1.1.8 action permit
Switch(config-igmp-profile)#exit
Switch(config)# interface gi1
Switch(config-if)#ip igmp filter 1
Switch(config-if)#exit
Switch(config)# exit
Switch# show ip igmp filter
Port ID | Profile ID
---------+--------------
gi1 : 1
gi2 : None
gi3 : None
--More--

4.10.14 ip igmp max-group

Command:
ip igmp max-groups <0-256>
no ip igmp max-groups
specifies profile ID
Specifies interfaces to display
Command Guide of WGSW-28040
152