Planet WGSW-28040 Command Manual page 250

no flow-control
Parameter:
off
on
Default:
Default port flow control is off.
Mode:
Interface Configuration
Usage Guide:
Use "flow-control" command to change port flow control configuration.
Use no form to restore flow control to default (off) configuration.
Example:
This example shows how to modify port duplex configuration.
Switch(config)# interface gi1
Switch(config-if)# flow-control on
This example shows how to show current flow control configuration
Switch# show interfaces gi1
Hardware is Gigabit
Full-duplex, Auto-speed, media type is Copper
flow-control is on
0 packets input, 0 bytes, 0 throttles
Received 0 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 multicast, 0 pause input
0 input packets with dribble condition detected
379 packets output, 31981 bytes, 0 underrun
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 PAUSE output
Disable port flow control.
Enable port flow control.
Command Guide of WGSW-28040
250