Lldp Holdtime-Multiplier - Planet WGSW-28040 Command Manual

<1-10>
Default:
lldp reinit-delay 2
Mode:
Global Configuration
Usage Guide:
This command globally configures the LLDP re-initial delay. This delay avoids LLDP generate too many PDU if the
port is up and down frequently. The delay starts to count when the port links down. The port would not generate LLDP
PDU until the delay counts to zero. The configuration could be shown by "show lldp" command.
Example:
This example sets LLDP re-initial delay to 5 seconds.
Switch(config)# lldp reinit-delay 5
Switch# show lldp
State: Disabled
Timer: 10 Seconds
Hold multiplier: 4
Reinit delay: 5 Seconds
Tx delay: 2 Seconds
LLDP packet handling: Flooding

4.13.4 lldp holdtime-multiplier

Command:
lldp holdtime-multiplier <2-10>
Parameter:
<2-10>
Default:
lldp holdtime-multiplier 4
Mode:
Global Configuration
Usage Guide:
Specify the LLDP re-initial delay time in unit of second.
Specify the LLDP hold time multiplier.
Command Guide of WGSW-28040
176