Command Guide Of Wgsw - Planet WGSW-28040 Command Manual

count <1-7>
last-member-query-
interval <1-60>
query-interval
<30-18000>
response-time
<5-20>
robustness-variabl
e <1-7>
Mode:
Global Configuration
Usage Guide:
'no ipv6 mld snooping vlan 1 (last-member-query-count | last-member-query-interval | query-interval |
response-time | robustness-variable)' will set the vlan parameters to default.
The cli setting will change the ipv6 mld vlan parameters admin settings.
The configure can use 'show ipv6 mld snooping vlan 1'.
Example:
This example shows how to set ipv6 mld snooping vlan parameters.
Switch(config)# ipv6 mld snooping vlan 1 fastleave
Switch(config)# ipv6 mld snooping vlan 1 last-member-query-count 5
Switch(config)# ipv6 mld snooping vlan 1 last-member-query-interval 3
Switch(config)# ipv6 mld snooping vlan 1 query-interval 100
Switch(config)# ipv6 mld snooping vlan 1 response-time 12
Switch(config)# ipv6 mld snooping vlan 1 robustness-variable 4
Switch# show ipv6 mld snooping vlan 1
MLD Snooping is globaly enabled
MLD Snooping VLAN 1 admin : disabled
MLD Snooping oper mode : disabled
MLD Snooping robustness: admin 4 oper 2
MLD Snooping query interval: admin 100 sec oper 125 sec
MLD Snooping query max response : admin 12 sec oper 10 sec
MLD Snooping last member query counter: admin 5 oper 2
MLD Snooping last member query interval: admin 3 sec oper 1 sec
MLD Snooping last immediate leave: enabled
MLD Snooping automatic learning of multicast router ports: enabled
Specify last member query interval to set. Default is 1
Specify query interval to set. Default is 125
Specify a response time to set. default is 10
Specify a robustness value to set, default is 2

Command Guide of WGSW-28040

223