Table 5-6 Run Led - Led Status Meaning; Supplying The System With Power - Siemens HiPath 3000 Service Manual

start_h3.fm
Starting Up HiPath 3000
Starting Up HiPath 3750 and HiPath 3700
5.3.2

Supplying the System with Power

Procedure
Step
1. Plug in the power supply cable on the power supply unit(s).
2. Monitor the Run LED of the CBCPR. The individual steps of the system boot
(Table 5-6) can be observed this way.
HiPath 3750 and HiPath 3700 RUN LED
The CBCPR has a RUN LED that indicates the system status.
Table 5-6 RUN LED - LED Status Meaning
RUN LED
Off
On
Off
On
Off
for 0.1 s
Flashing
0.5 s on/0.5 s off
Flashing
0.1 s on/0.1 s off
1 The flashing rhythm depends on the load. The higher the system load the slower the flashing rhythm.
The HiPath 3750 or HiPath 3700 is ready when the date "1. JAN 00" and the time
>
"00:00" appear in the display on the system telephone.
5-12
No power
Reset switch pressed briefly
Reset switch held down for more than 5 seconds (LED is extinguished
to acknowledge that a reload has begun)
System boot
Load operation: APS in SDRAM, loadware, and card data.
Normal operating state (zero load)
MMC removed or defective
Activity
Meaning
1
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual