Figure 3-82 Pin Assignments In Mw Jacks - Siemens HiPath 3000 Service Manual

Connecting ISDN telephones
Depending on the system, you can set up a maximum of four internal S
A maximum of eight ISDN terminals can be addressed on each S
The system does not assign the MSN until the S
can be read out via administration.
When you set up an S
the system. The S
0
zure.
If no MSN is entered in the terminal, a default MSN is automatically assigned after
>
you change the S
Configuring an S
0
S telephones cannot be directly connected to an STLSX board's Mini-Western jack via the ca-
0
ble supplied. You must first install a jack with cross-connected cables (see Figure 3-77).
Assignment of MW jack pins 1- 8:
8-pin
8 7 6 5
SR SX SX SR
4-pin
4 3
SR SX SX SR
Figure 3-82 Pin Assignments in MW Jacks
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
bus, it is assigned an MSN. This MSN is the first free station number in
0
station is immediately available under this MSN, without an outgoing sei-
port to "Euro bus" in system administration.
0
bus with a Mini-Western jack
4 3 2 1
2 1
port is configured on the "Euro bus"; the MSN
0
6-pin
6 5 4
SR SX SX SR
Always establish contact on the
center four pins.
Boards for HiPath 3000
Peripheral Boards
buses (S 1 to S
0 0
bus.
0
3 2 1
boards.fm
4).
0
3-203