Setting Up A Single Cabinet; Figure 4-1 Hipath 3800 - Setting Up The Basic Cabinet - Siemens HiPath 3000 Service Manual

Hide thumbs Also See for HiPath 3000:

Table of Contents

Setting Up a Single Cabinet

To guarantee sufficient ventilation for the system cabinet, allow a minimum clear-

ance of 50 mm between the base of the cabinet and the ground.

Place the system cabinet in the installation site and make sure that it is level and

Check that the space between the base of the cabinet and the ground is at least

If necessary, set up the basic cabinet in the following way:

Unscrew lock nut (Figure 4-1, A) on one of the cabinet feet using an open-end

wrench (wrench size = 13 mm).

Adjust the height of the cabinet foot by turning the screw nut (Figure 4-1, B)

so that the cabinet is steady and the minimum clearance is observed.

Fix the cabinet foot in position by tightening the lock nut (Figure 4-1, A).

Basic cabinet setup

HiPath 3800 - Setting Up the Basic Cabinet

P31003-H3550-S403-4-7620, 02/05

HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual

Installing HiPath 3000

Installing HiPath 3800

Table of Contents