Relocate/Transfer Application Processor Software (Aps); Hipath Software Manager; Transferring An Aps Of Hipath 3000 By Replacing The Mmc - Siemens HiPath 3000 Service Manual

Hide thumbs Also See for HiPath 3000:

Table of Contents

Relocate/Transfer Application Processor Software (APS)

APS replacement/transfer is not possible with HiPath 5000. You must perform a

complete software upgrade.

For system software updates, a distinction is made between

HiPath 3000 systems without HiPath Software Manager and

HiPath 3000 systems with HiPath Software Manager.

For networked HiPath 3000 systems with HiPath 5000 Server, an APS update can only be per-

formed with HiPath Software Manager.

APS Replacement/Transfer for HiPath 3000 Systems Without HiPath

Software Manager

Two memory areas are reserved for the application processor software on the MMC. To be able

to store two complete APS and to keep the transfer time as low as possible, part of an APS is

stored in a compressed format. The APS is decompressed after it has been transferred from

the MMC to the SDRAM area of the central control board.

APS replacement is only possible within a version and if a logical, compatible CDB

is available.

Create a backup of the current CDB and save on a customer disk for security

Remove MMC with "old" APS.

The flashing Run LED (0.1 s on/0.1 s off) indicates that the MMC is missing.

The system remains active for call processing.

Install new MMC with "new" APS.

The system creates an automatic CDB backup and thus saves the current cus-

tomer database (CDB) to the new MMC.

An automatic reset is then performed (hard restart for entire system with the

current CDB).

P31003-H3550-S403-4-7620, 02/05

HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual

Service and Maintenance Tasks

Table of Contents