Aps Transfer - Siemens HiPath 3000 Service Manual

Hide thumbs Also See for HiPath 3000:

Table of Contents

Service and Maintenance Tasks

Path 3000 Manager E or Assistant T (menu item 29-1-2) to make the neces-

APS transfer

The APS Transfer feature is available with the HiPath 3000 Manager E. It facilitates

an on-site APS transfer by connecting directly using the V.24 interface.

an APS transfer via remote service from a central service center using the integrated an-

alog or digital modem or via LAN.

This feature transfers the new APS in its entirety and stores it in the available area of the MMC.

After the transfer, the checksum is analyzed. The system subsequently reports whether or not

an error was found.

If so, you have to delete the transferred APS.

the APS transfer was successful.

You can then activate the APS immediately or at a later time.

Resetting the system initiates the changeover from the old APS to the new APS. If problems

occur during this process, the old APS is reactivated. Once the changeover is successful, the

old APS is deleted from the MMC.

In case of power outage, the SDRAM content that has no battery backup and the active APS

are completely lost. By re-accessing the current APS on the MMC, the system can be restored

to the state it was in prior to the power outage.

stamp" to verify that the new APS has been activated. Use Hi-

P31003-H3550-S403-4-7620, 02/05

HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual

Table of Contents