Announcement And Music Modules - Siemens HiPath 3000 Service Manual

3.4.5

Announcement and Music Modules

Caution
7
Place the central control board on a flat surface before inserting a subboard. Other-
wise you may damage the board.
Introduction
The HiPath 3000 systems use different modules or boards for playing announcements and mu-
sic on hold. For details on connecting these boards, refer to the manufacturer's installation in-
structions.
The following HiPath Xpressions Compact boards support music on hold in V4.0
>
SMR-7 or later and announcements in V5.0 or later:
IVML8, IVML24 (HiPath 3750, HiPath 3700)
●
IVMNL, IVMN8 (HiPath 3800)
●
IVMP8 (not for U.S.), IVMP8R (not for U.S) (HiPath 3350, HiPath 3300)
●
IVMS8, IVMS8R (HiPath 3550, HiPath 3350, HiPath 3500, HiPath 3300)
●
For detailed information on HiPath Xpressions Compact, startup and administration,
see the manual for the product (see Section 1.6, "Information on the Intranet": Elec-
tronic Documentation on Com ESY Products).
Overview
Table 3-159 Announcement and Music Modules
Module/ Part number
Board
EXM S30817-Q902-
B401
EXMR S30122-K7403-Z
MPPI S30122-K7275-B
MPPI (not S30122-K5380-
for U.S.) X200
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
Used in HiPath 3550 and HiPath 3350 (wall housing),
●
see Figure 3-142.
Connected via cable to X4 connector on CBCC/CBCP.
●
Used in HiPath 3500 and HiPath 3300 (19-inch hous-
●
ing).
Board installed directly on CBRC (X19 and X20).
●
Connected via cable to Cinch jack on the front panel
●
(see Figure 3-143).
Used in all HiPath 3000 systems
●
Board installed directly on the central control board
●
(X19 and X20).
Used in HiPath 3550 and HiPath 3350 (wall housing).
●
Connected via cable to X4 connector on CBCC/CBCP.
●
Boards for HiPath 3000
Notes
boards.fm
Options
3-329