Isdn Terminals For Hipath 3000 - Siemens HiPath 3000 Service Manual

wclient.fm
Workpoint Clients

ISDN Terminals for HiPath 3000

10.11 ISDN Terminals for HiPath 3000
An S bus in the HiPath 3000 system family can support up to eight ISDN terminals. Each ter-
0
minal can be dialed selectively under its multiple subscriber number or station number.
The features that can be activated depend on the type of S
tures are supported depending on the terminal used. Analog station users can activate system
features by means of code procedures. The telephones support only those system features
which can be activated in the idle state.
The dialing behavior of ISDN terminals corresponds to that of DP terminals. The substitute
codes "75" and "76" can be used for the characters "*" and "#" which cannot be used in the ISDN
protocol.
Boards for connecting ISDN terminals
System
Hardware requirements Free S
Refer to Section 9.2.2 for information on upgrading peripheral boards for HiPath 3750 and Hi-
Path 3700.
Connecting with an optiPoint ISDN adapter
It is also possible to connect an ISDN device to an existing optiPoint 500 telephone
>
using an optiPoint ISDN Adapter (except for optiPoint 500 entry and optiPoint 500
economy).
10-108
HiPath 3800 HiPath 3750
HiPath 3700
port on Free S
0
STMD3
terminal used. Different ISDN fea-
0
HiPath 3550
HiPath 3500
port on Free S
0
STMD8 CBCC
CBRC
STLS2/4
STLS4R
STLSX2/4
STLSX4R
P31003-H3550-S403-4-7620, 02/05
HiPath 3000 V5.0, HiPath 5000 V5.0, Service Manual
HiPath 3350
HiPath 3300
port on Free S port on
0 0
CBCC
CBRC
STLS2/4
STLS4R
STLSX2/4
STLSX4R