Esc+Fc Print Circle - SATO CL4NX Programming Reference Manual

7.8 Modification
7.8

ESC+FC Print Circle

Print Circle
ESC
Hexadecimal
code <1B>
16
Initial value Nil
When the power switch is OFF
Valid range and
term of Valid range within items
command
Valid range between items
[Function]
Specifying the print of circle.
[Format]
<FC>,aaa,bbb(,c,d)
●Parameter
a[Radius]
b[Line width]
c[Sectional number]
d[Pattern]
●Sectional number
Section 0 Section 1
[Coding Example] Solid line circle of 100 dots in radius, 8 dots in line width
<A>
<V>200<H>200
<FC>,100,8,0,0
<Q>1
<Z>
[Supplementary Explanation]
1. When the value outside of the range is specified for sectional number, it will be processed as "0". In this case, this
will not be a command error.
2. When the value outside of the range is specified for the designation of pattern, it will be processed as "0". In this
case, this will not be a command error.
3. When the print start position exceeds the printable area, the printing is executed. (This raises a command error.)
4. This command sets the base reference point to the center of a circle.
0,0
<H>200
5. This command can be registered to the format.
6. If setting the glid line wider, it will be widened inward.
[Valid Range]
Model
CL4NX
CL6NX
FC
<46> <43>
16
16
= Valid range: 5 to 999 dots
=Valid range: 1 to 999 dots
= Valid range: 0 to 8
See the details listed below.
= Valid range: 0 to 3
0: Solid line (black)
1: Gray 1
2: Gray 2
3: ray 3
Section 2 Section 3 Section 4
<V>200
100 in radius
Valid range (dot)
Radius
5 to 999
26
ESC+FC
Parameter
,aaa,bbb(,c,d)
The set parameter is not maintained.
The set parameter becomes invalid.
The set parameter becomes invalid.
When omitted: 0 (omissible)
When omitted: 0 (omissible)
Section 5 Section 6
Line width
1 to 999
Section 7 Section 8