Print Head Front And Rear Alignment (Print Balance) - SATO e Series Service Manual

Section 5. Mechanical Adjustments

5.4 Print Head Front and Rear Alignment (Print Balance)

STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cord.
2. Raise the access cover.
3. Loosen (2) adjustment fixed screws.
4. Insert hexagonal wrench or pin into adjustment socket. Adjust forward or
backward by turning the axle.
Backward rotation shifts the head position backward.
Forward rotation shifts the head position forward.
Perform this procedure with Section 5.3 to achieve the best print value.
PN 900109
Rev. A
5-4
INSERT HEXAGONAL
WRENCH OR PIN THROUGH
ADJUSTMENT SOCKET
AND ROTATE
FORWARD OR BACKWARD
SATO M-10e TT/DT Printers Service Manual
LOOSEN (2) SCREWS
(ACCESS THROUGH
HEAD COVER)
HEAD COVER