LM315GC
Maintenance
Adjusting Work Speed
Follow the steps below to make adjustments.
( - #30420)
1.
Set the reel rotation switch to the "MOW"
(reel rotation) position.
A
Adjusting Work Speed_001
1
A
B
2.
Loosen the locknut on the side of the reel
rotation switch to adjust the length of the
bolt.
Length of the bolt (Longer): Slower
・
Length of the bolt (Shorter): Faster
・
Once the adjustment has completed, be
sure to lock with the nut.
Adjusting Work Speed_002
1
A
(#30421 - )
1.
Depress the mower pedal to lower the
mower units.
2.
Loosen the locknut on the side of the rod
head for the right cylinder to adjust the
length of the bolt.
Length of the bolt (Longer): Slower
・
Length of the bolt (Shorter): Faster
・
Page 5-16
1
B
mh4pyw-006
Reel rotation switch
Rotate
Stop
A
cs6lrm-001
Lock nut
Length of the bolt
Once the adjustment has completed, be
sure to lock with the nut.
Adjusting the Neutral Position of the Piston
Pump
Caution
Make sure not to touch rotating tires.
Caution
When adjusting the neutral position, pay close
attention to abrupt start of the machine.
Place the jacks beneath the jack-up points,
and then lift the machine until all the tires get
off the ground.
If the machine moves forward or backward
while the traveling pedals are released, they
1
are not set to the neutral position.
Follow the steps below to make adjustments.
1.
Stop the engine.
2.
Place the jacks beneath the jack-up points,
and then lift the machine off the ground.
(See "Jack-up Points" (Page 5-6) .)
3.
Make sure that no tires get contact with the
jack stand.
4.
Start the engine, and rev it up to the
maximum rpm.
5.
Adjust the neutral position.
[1]
Loosen the lock nut.
2
1
A
Adjusting Work Speed_003
1
Rod head
2
Lock nut
A
Length of the bolt
Maintenance (Main Body)
cs6lrm-002