LM315GC
Maintenance
Attaching Reel Cutter (Cutting Cylinder)
Caution
Both the reel cutter (cutting cylinder) and the
bed knife (bottom blade) are edged tools.
Handle them carefully, since they could cut
your hands and feet.
Follow the instruction below to replace the reel
cutter bearing (right/left) and seal.
Use 30204JRP6 as bearing.
1.
Fill up (Excelite EP No.2) to the bearings and
seal.
2.
Attach the reel cutter (cutting cylinder) to the
frame like the figure below.
3.
Tighten the inner nut and check the bearing
for backlash.
4.
Loosen the inner nut at the level that the reel
cutter (cutting cylinder) can be rotated lightly
by your hand and you don't feel the
backlash.
Tightening torque: 7 N-m (71.4 kgf-cm /
61.96 lb-in)
5.
Tighten the outer locknut.
5
4
3
1
Attaching Reel Cutter (Cutting Cylinder)_001
1
2
3
4
5
6
7
8
Page 5-12
6
7
1
wggg9e_001
Bearing
Seal
Reel cutter (Cutting cylinder)
Inner nut
Outer nut
Key
Cover
Pin
Maintenance (Main Body)
Removing/Installing Tires
Front Tire
Follow the steps below to remove the front
tire:
1.
Loosen the bolts.
2.
Securely place the jack beneath the jack-up
point of the front right/left frame area, and
then raise it until the tire lifts off the ground.
(See "Jack-up Points" (Page 5-6) .)
3.
Remove the bolts.
4.
Remove the tire from the wheel mounting
2
base.
Caution
Refer to the Tightening Torque Table.
8
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening etc.
Important
Tighten the bolts in the tightening order
(crosswise).
For installing the front tires, reverse the
removing procedure.
Rear Tire
Follow the steps below to remove the rear
tires:
[2WD]
1.
Securely place the jack beneath the jack-up
points of the engine mount frame area, and
then raise it until the tire lifts off the ground.
(See "Jack-up Points" (Page 5-6) .)
Front Tires_001
1
Heat-treated bolt
Maintenance (Main Body)
1
lm2ieh-004