Baroness LM315GC Owner's Operating Manual page 51

Important
The thermo-start lamp turns off at the
specified time. However, the lamp turning off
is not related to the glow plug generating heat.
If the ignition key is left in the "GLOW"
position after the lamp is turned off, the plug
will still generate heat.
The lamp will stay illuminated for five seconds.
7. Switch the ignition key to the "GLOW"
position.
1
Procedure to Start Engine_004
1 Ignition key
A OFF
B ON
C GLOW
D START
8. Make sure that the glow plug is generating
heat and the thermo-start lamp is turned on.
1
Procedure to Start Engine_005
1 Charge lamp
2 Thermo-start lamp
3 Oil pressure lamp
Procedure to Start / Stop Engine
A
B
C
D
v2e27i-010
2 3
v2e27i-011
Handling Instructions
Caution
Quickly returning the ignition key from the
"START" position to the "ON" position may
result in damage to the machine.
9. After the thermo-start lamp turns off,
immediately set the ignition key to the
"START" position.
10. When the starter starts rotating and the
engine starts, slowly return the ignition key
to the "ON" position.
11. Make sure that the charge lamp and engine
oil pressure lamp turn off.
If they do not turn off, stop the engine and
inspect the machine.
12. Shift the throttle lever to the turtle icon (low
speed), and then warm up the engine for
1-2 minutes.
13. Gradually move the throttle lever to the
rabbit icon (high speed).
Procedure to Stop Engine
1. Set the traveling pedal to the neutral
position.
2. Pull the parking brake lever.
3. Set the reel rotation switch to the "TRAVEL"
(reel stop) position.
4. Shift the throttle lever to the turtle icon (low
speed), and then warm up the engine for
1-2 minutes.
5. Switch the ignition key to the "OFF"
position.
6. Make sure that the engine has stopped.
7. Remove the ignition key.
8. Leave the driver's seat.
9. Close the fuel cock.
The fuel cock is located beneath the fuel
tank.
LM315GC
Page 4-27