Cutting Work; Transporting; Removing Grass Catcher; Transporting Procedure - Baroness LM315GC Owner's Operating Manual

LM315GC
Handling Instructions

Cutting Work

Cutting Work

Warning
Do NOT start to move or stop the machine
abruptly.
To do so is very dangerous. In addition, it may
damage the hydraulic system or result in oil
leakage.
Warning
Set the reel rotation switch to the "TRAVEL"
(reel stop) position except during mowing or
backlapping.
Caution
In case of 2WD/3WD model, travel in 2WD
mode since it is dangerous to travel on steep
downward slopes, wet road surface or
downward slopes of wet lawn in 3WD mode.
Rear tire going into a skid may cause loss of
traveling control.
Caution
Be sure to install the grass catchers.
Otherwise, flying objects from the mower units
may hit your feet.
Important
In case of 2WD/3WD model, whenever the
reel rotation switch is set to the "MOW" (reel
rotation) position, the drive mode is put into
3WD regardless of the position of the
2WD/3WD selector switch.
1. Install the grass catchers.
2. Start the engine. (See "Procedure to Start
Engine" (Page 4-26) .)
3. Raise all mower units.
4. While pressing the push button, release the
parking brake lever.
5. Shift the throttle lever to the rabbit icon (high
speed) to run the engine at the maximum
speed (3,000 rpm).
6. Set the reel rotation switch to the "MOW"
(reel rotation) position.
Page 4-42
7. Start the work following the procedure below.
[1] Depress the traveling pedal.
[2] Depress the mower pedal when the
mower unit reaches the collar of the
green.
[3] Lower the mower units to start rotating the
reel cutters (cutting cylinders).
Note:
During the work, the reel cutters (cutting
cylinders) will rotate or stop in sync with the
up and down motion of the mower units.
8. Set the reel rotation switch to the "TRAVEL"
(reel stop) position after the operation
completed.

Removing Grass Catcher

1. To discard the collected grasses, set the reel
rotation switch to the "TRAVEL" (reel stop)
position.
2. Lift up the grass catcher and remove it.
Removing Grass Catcher_001
1

Transporting

Transporting Procedure

When loading the machine into a trailer or a
truck to transport it, drive the machine forward.
When unloading, drive the machine in reverse.
lovz39-001
Grass catcher
Cutting Work