LM315GC
Handling Instructions
Reel Reverse Lever
Caution
Operate the reel reverse lever while the
rotation of the reel cutter (cutting cylinder) is
stopped, and adjust it to the position suitable
for your work.
The reel reverse lever is located at the upper
part of the gear case of the mower unit.
If you set the lever to Normal, it starts cutting
rotation, set to Reverse for back lapping
rotation and Neutral for free rotation.
Reel Reverse Lever_001
1
A
B
C
Page 4-36
32w9j9-004
Reel reverse lever
Normal rotation
Neutral
Reverse rotation
Transmission Selector Lever
Caution
The transmission selector lever should be
operated while the engine rotation is stopped,
and adjusted to the position suitable for your
work.
Important
For the LM315GC (for fields), normally cut
with the lever set to the "L" position.
The transmission selector lever is located at
the upper part of the transmission, behind the
driver's seat. When the lever is shifted to "H,"
A
the reel cutters (cutting cylinders) rotate fast;
on "L" they rotate slowly; on "LAP" they rotate
B
more slowly, at a suitable speed for back
lapping.
C
1
3
1.
H
The reel cutters (cutting cylinders) rotate
faster, and the clip pitch (cutting interval)
becomes shorter.
This is suitable for the work at a good turf
condition.
2.
L
The reel cutter (cutting cylinder) rotates
slower compared to when it is at "H" and the
clip pitch becomes longer.
This is suitable for the work at the turf
condition not so good.
1
Transmission Selector Lever_001
1
H
2
L
3
LAP
Operation of Each Section
2
zzpqiy-002