Travel Of Machine; Fuel Gauge; Moving The Machine; Towing The Machine - Baroness LM315GC Owner's Operating Manual

Fuel Gauge

The fuel gauge is located on the fuel tank.
This instrument indicates the quantity of fuel
inside the fuel tank.
Fuel Gauge_001
1 Fuel gauge

Travel of Machine

Moving the Machine

Warning
Set the reel rotation switch to the "TRAVEL"
(reel stop) position except during mowing or
backlapping.
Caution
In case of 2WD/3WD model, travel in 2WD
mode since it is dangerous to travel on steep
downward slopes, wet road surface or
downward slopes of wet lawn in 3WD mode.
Rear tire going into a skid may cause loss of
traveling control.
Important
In case of 2WD/3WD model, whenever the
reel rotation switch is set to the "MOW" (reel
rotation) position, the drive mode is put into
3WD regardless of the position of the
2WD/3WD selector switch.
1. Start the engine.(See "Procedure to Start
Engine" (Page 4-26) .)
2. Raise all mower units.
3. While pressing the push button, release the
parking brake lever.
4. Slowly depress the traveling pedal.
5. The machine can start traveling.

Travel of Machine

Towing the Machine

If the machine does not travel due to engine
trouble, etc., you can move it in the following
ways:
Pushing by hand
･
1
･ Towing (See the following instruction.)
Caution
Tow the machine at a low speed while paying
close attention.
Caution
Do not touch the unload valve except when
96ltfa-004
towing the machine.
Caution
Before restarting the engine, be sure to close
the unload valve.
1. Stop the engine. (See "Procedure to Stop
Engine" (Page 4-27) .)
2. Pull the parking brake lever and chock the
wheels.
3. The unload valve is located at the lower right
of the frame.
While pressing the unload valve, rotate it 90
degrees (vertically) to open.
4. While pressing the push button, release the
parking brake lever and remove the wheel
stopper.
5. Tow the machine slowly.
Handling Instructions
A
Towing the Machine_001
1 Unload valve
A Onload
B Unload
LM315GC
B
gay3t1-008
Page 4-41