Fuel - Baroness LM315GC Owner's Operating Manual

LM315GC
Handling Instructions
Change of Engine Oil
For details on handling the engine, please
refer to the separate Engine Handling Manual.
Warning
When you change the engine oil, be sure to
drain it into a bowl and discard it in
accordance with local laws and regulations.
Caution
Be careful with hot oil, which could cause
burns if it contacts your skin.
Important
Be sure to use engine oil that is classified as
API Service Grade CF or higher, with an SAE
Viscosity that is appropriate for the operating
environment (ambient temperature).
Important
Securely tighten the oil level gauge and oil
filler cap.
Change the engine oil more frequently if the
engine oil is contaminated and, especially, if
you use the machine in dusty areas or
operate the engine at high loads or in high
temperatures.
1. Move the machine onto a level surface,
stop the engine, remove the drain plug
while the engine oil is warm, and then drain
the oil into a bowl.
2. Replace the drain plug in the engine.
1
Change of Engine Oil_001
1
Page 4-12
gui678-011
Drain plug
3. Through the oil filler cap, supply new
engine oil until the oil reaches a level in
between the upper and lower limit lines on
the oil level gauge.
Engine oil quantity is approximately 2.8 dm
(2.8 L).
4. Replace the oil filler cap.
1
Change of Engine Oil_002
1
5. It will take a while for the supplied engine oil
to descend into the oil pan.
Check the oil level again 10 to 20 minutes
after filling the oil.

Fuel

Inspection of Fuel Quantity
With the machine on a level surface, observe
the fuel gauge on the fuel tank to check the
fuel level.
Inspection of Fuel Quantity_001
1
Oil filler cap
1
guc5f6-007
Fuel gauge
Inspection Before Use
3
kx9ti-004