Pilot Lamps - Baroness LM315GC Owner's Operating Manual

LM315GC
Handling Instructions
Remove the load from the engine, idle the
machine for five minutes, stop the engine, and
then inspect the machine and perform any
necessary maintenance.
If the water temperature exceeds 105 degrees
Celsius, a buzzer will sound.(Intermittent tone)
1
Water Temperature Gauge_001
1

Pilot Lamps

Charge Lamp
The charge lamp is the left pilot lamp located
in the operation panel.
It turns on when the ignition key is set to the
"ON" position before the engine starts. It turns
off when the engine starts and the alternator
starts operating properly.
If this lamp illuminates while you are operating
the machine, stop the engine immediately,
and then inspect the machine and perform
any necessary maintenance.
1
Charge Lamp_001
1
Page 4-40
igozke-001
Water temperature gauge
ifzqmc-002
Charge lamp
Thermo-start Lamp
The thermo-start lamp is the middle pilot lamp
located in the operation panel.
When the ignition key is set to the "GLOW"
position, it illuminates as the glow plug
generates heat.
Illumination of the thermo-start lamp is
controlled by the glow lamp timer, and the
lamp is turned off after a specified amount of
time passes.
The duration of illumination indicates an
approximate period of time required for warm-
up, and has been fixed at five seconds.
Thermo-start Lamp_001
1
Oil Pressure Lamp
The oil pressure lamp is the right pilot lamp
located in the operation panel.
It turns on when the ignition key is set to the
"ON" position before the engine starts. It turns
off when the engine starts and engine oil
pressure is generated properly.
If this lamp illuminates while you are operating
the machine, stop the engine immediately,
and then inspect the machine and perform
any necessary maintenance.
Oil Pressure Lamp_001
1
1
q44uug-002
Thermo-start lamp
1
Oil pressure lamp
Instruments
1ldikn-002