Baroness LM315GC Owner's Operating Manual page 47

Adjustment of Front Roller
1. Set the slide caliper to the required cutting
height, adjust the neck position of the
cutting height screw of the cutting height
gauge and securely lock with a fly nut.
2. Loosen the nut which fixes the roller
bracket of the front roller.
3. Apply the cutting height gauge to the front
and rear rollers at each edge of left and
right of the mower unit.
4
8
1
3
7
Adjustment of Front Roller_001
1 Cutting height
2 Cutting height gauge
3 Cutting height screw
4 Nut
5 Front roller
6 Rear roller
7 Bed knife (bottom blade)
8 Roller adjuster
4. Adjust the front roller up and down by the
roller adjuster to determine the position of
the front roller, in order not to have a gap
with the neck position of the cutting height
screw of the cutting height gauge, at the
edge of the bed knife.
4
Adjustment of Front Roller_002
Adjustment Before Operating
5
2
2 6
3kws2a-010
1
3
2
3kws2a-007
Handling Instructions
1 Bed knife (bottom blade)
2 Cutting height screw
3 Cutting height gauge
4 Cutting height
5. Repeat the same process at the opposite
side for the adjustment of cutting height.
6. Tighten the nuts that secure the right and
left roller brackets to secure them firmly.
7. Again, make sure that the cutting height is
at the required position by applying the
cutting height gauge to the front and rear
rollers at each edge of right and left of the
mower unit.
LM315GC
Page 4-23