Avaya 9608 Administrator's Manual page 84

Administering Deskphone Options
Parameter name
PHY1STAT
PHY2PRIO
PHY2STAT
PHY2VLAN
PINGREPLYV6
PROCPSWD
PROCSTAT
PUSHCAP
Administering 9608/9608G/9611G/9621G/9641G IP Deskphones H.323
84
Default value Description and value range
1 Ethernet line interface setting 1=auto-negotiate, 2=10
Mbps half-duplex, 3=10 Mbps full-duplex, 4=100 Mbps
half-duplex, 5=100 Mbps full-duplex, and 6=1000 Mbps
full-duplex, if supported by the hardware.
0 Layer 2 priority value for frames received on or forwarded
to the secondary Ethernet interface. Set this parameter
only when VLAN separation is 1 (enabled). Values are
from 0 through 7 and correspond to the drop-down menu
selection.
1 Secondary Ethernet interface setting, 0=Secondary
Ethernet interface off/disabled, 1=auto-negotiate, 2=10
Mbps half-duplex, 3=10 Mbps full-duplex, 4=100 Mbps
half-duplex, 5=100 Mbps full-duplex), and 6=1000 Mbps
full-duplex if supported by the hardware.
0 VLAN identifier used by frames received on or forwarded
to the secondary Ethernet interface. Set this parameter
only when VLAN separation is "1" (enabled).
Value is 1-4 ASCII numeric digits from 0 to 4094. Null is
not a valid value, nor can the value contain spaces. If this
value is set by LLDP using the Port VLAN ID TLV value,
the value will not change regardless of settings from other
sources. For more information, see
precedence
1 Specifies whether ICMPv6 Echo Reply messages will be
sent or not. Valid values are: 0= ICMPv6 Echo Reply
messages will not be sent. 1= ICMPv6 Echo Reply
messages will be sent only in reply to received Echo
Request messages with a Destination address equal to
one of the deskphone's unicast IPv6 addresses. 2=
ICMPv6 Echo Reply messages will be sent in reply to
received Echo Request messages with a Destination
address equal to one of the unicast, multicast or anycast
IPv6 addresses of the deskphone.
27238 Text string containing the local dial pad procedure
password (Null or 1-7 ASCII digits). If set, password must
be entered immediately after accessing the Craft Access
Code Entry screen, either during initialization or when
Mute or the Contacts button for the 9610 is pressed to
access a craft procedure. Intended to facilitate restricted
access to local procedures even when command
sequences are known. Password is viewable, not hidden.
0 Local dial pad Administrative Options status (0=all
Administrative (Craft) Options are allowed, 1=only VIEW is
allowed).
2222 Push capabilities. Valid values are any three or four digit
combination using only the digits 0, 1, or 2.
Comments? infodev@avaya.com
About parameter data
on page 17.
June 2014